How to use each Tuftly tool

Four short chapters, one per tool, in the order most people use them at night. Each one covers the steps, how to look after the tool, and what it isn't for.

None of it should hurt. If something does, stop, go gentler or smaller, and ask your dentist or hygienist at your next visit.

Angled Floss Picks

  1. Start at the back

    Begin with the molars while your hand is fresh. The tilted head lets you reach them with the handle pointing out of your mouth, not twisted sideways.

  2. Work the floss down

    Ease the floss between two teeth with a small sawing motion. If it snaps through the contact, slow down so it doesn't hit the gum hard.

  3. Clean both sides

    Curve the floss against one tooth, slide it a little under the gumline, and draw it up. Repeat on the neighboring tooth before moving on.

  4. Lift what's left

    Run the pointed end of the handle along the gumline to lift out anything the floss loosened.

Product image: tuftly-floss-picks-detail, 3:2

One pick per session, then it goes in the trash. Keep the carton closed and dry.

Wide gaps, or the space around braces, bridges, and implants. A brush fits those better.

Shop Angled Floss Picks

Interdental Brushes

  1. Find each gap's size

    With the Sizing Pack, start at size 0 in one gap and move up until the brush touches both sides with a little drag. Note the size and repeat for the next gap. Two sizes across your mouth is common.

  2. Go in straight

    Hold the brush level with the gap and slide it in without bending the wire. At the back, bend the neck once to make an angle, then leave it.

  3. A few strokes

    Move it in and out a few times. Don't twist it in place or force it. If it won't go in, use the size below.

  4. Rinse and cap

    Rinse under the tap, let it air dry, and put the cap on for travel.

Product image: tuftly-interdental-brushes-detail, 3:2

Change a brush every 5 to 10 days, or sooner if the wire bends or the bristles flatten. A bent wire can scratch.

Gaps where floss barely fits. If size 0 won't go in without pushing, that gap is a floss pick gap.

Shop Interdental Brushes

Soft Picks

  1. Rinse the tip

    Wet rubber slides between teeth more easily than dry rubber.

  2. Slide it in at a slight angle

    Enter each gap gently, tilted a little toward the biting surface so the tip doesn't poke the gum.

  3. Move it in and out

    A few short strokes per gap. The fins do the cleaning; pressing harder adds nothing.

Product image: tuftly-soft-picks-detail, 3:2

Use each pick once. Keep the case closed between uses so the picks stay clean in a bag.

Very tight gaps where the tip won't enter, or wide gaps where a brush in your size fits better.

Shop Soft Picks

Steel Tongue Cleaner

  1. Stick your tongue out

    It flattens the surface and keeps the back of your tongue where you can reach it.

  2. Set it and pull

    Hold both ends, place the curve as far back as is comfortable, press lightly, and pull it forward to the tip.

  3. Rinse between passes

    Rinse the strip after each pass. Three passes is plenty.

Product image: tuftly-tongue-cleaner-detail, 3:2

Rinse after use and let it dry. Every week or so, boil it for a few minutes or put it in the dishwasher.

Treating bad breath. If it stays bad despite good cleaning, that's a question for a dentist.

Shop the Steel Tongue Cleaner

When to replace each one

Two tools are single use, one wears out on a schedule, and two last until they show wear.

Angled Floss Picks
After each session
Interdental Brushes
Every 5 to 10 days, or when the wire bends
Soft Picks
After each session
Steel Tongue Cleaner
When it bends or the edge feels rough, often years

Not sure which tools you need?

The size finder works it out from how floss feels in each part of your mouth.

Shop the four tools

Tuftly sells at-home hygiene tools. It does not provide dental care, diagnosis, or advice, and its tools do not replace visits to a dentist or hygienist.

Email
support@dental.example
Phone
[Placeholder for Phone Number]
Mailing address
[Placeholder for Address]